You choose the correct fiber optic jumper should depend on your plan to the purpose of using the jump line in a network.The following is one of the important steps you can follow, so that you get the most suitable type, make your job easier:
Step # 1: select the appropriate connector type
The type of connector can be, FC, SC, LC, SC MPO and MTP.Fiber optic jumper wire | fiber optic jumper on both ends with one of these types of connectors.
If the device at the end of the port is the same, you can use a similar LC - - SC, LC, SC or MTP - the combination of the MTP.If they are not the same, you can use the LC, ST, LC - SC or MPO - MTP combination, etc.
Step # 2: choose single mode or multimode appropriate
You know that several types of the differenceFiber optic jumper?So, in general, single mode line use 9/125 um glass fiber.On the other hand, multimode use 50/125 62.5/125 um um or glass fibre.
If you are creating a network connection for data transmission over a long distance, choosing the type of the single mode optical fiber cable.For short distances, multimode cable type is a good way to finish the work.
Step 3: select the appropriate typeFiber optic jumper
figure
Can be seen from the diagram, the simplexFiber optic jumperOnly a wire to type at the end of the optical fiber connector.
Duplex, on the othermanbetx体育开户 hand, the ha //www.vg3reginf.com/duplex-armored-fiber-optic-patch-cable-single-mode-fiber-optic-patch-cord-lc/upc - fc/upc HTMLS two patch cable placed side by side.You will usually find duplex line in the transceiver.
Your connection type determines that you are need to use the simplex or duplex type of wire.Some connection need simplex, while others need a duplex.So, you just need to find out what your connection need.
Step # 4: choose the appropriate cable length
The length of the fiber optic jumper wire is usually between 0.5 m and 50 m.As long as meet your needs, you can use any length of cable.
In order to avoid waste or used may not be long enough cable to finish your work, please measure the distance between the device you want to connect.Can add small amount, but not too long.
Step 5: select the correct type of connector polishes
Poland's type is the UPC or APC.In order to make the right choice, you should know the difference between the two kinds of fiber optic jumper.
The wastage of the APC generally below the UPC.Therefore, in terms of performance, they are better.
You should also note that now the APC connectors are widely used in many applications.You will be in FTTX, PON, and found them in wavelength division multiplexing (WDM) and so on.
APC and UPC in the aspect of color is also different.Here is a photo of the two:
figure
Green is the APC, blue is the UPC.
Step 6: select the correct type of cable sheath
Cable sheath is usually divided into three types.These are:
- Polyvinyl chloride (PVC)
- Fiber insulation pumping chamber (OFNP)
- Low smoke zero halogen (LSZH)
So, what is the difference between these three type of jacket?Well, they are different on the features and functions.
PVC is not easy to degradation.Their antioxidants.Therefore, you can appear in the center of the wiring of the horizontal line safely use them.
OFNP space in the building component.Space to allow the free flow of air.As a result, they are most suitable for vertical run between floors.
If you want to type flame retardant cable, LSZH is the best choice.Between the floors of the building use, they are the best.
You can look at their functions, you can easily select the most appropriate type for your work.
